Protective Keypad Cover for Ingenico ISC250 & ISC480 Credit Card Terminals
Description
The ISC250 and ISC480 keypads handle constant hand contact throughout the day, customers keying in PINs, tapping through prompts, and signing off on transactions. Over time, that repeated contact leaves behind oils, dust, and moisture that build up in the seams around the keys, often going unnoticed until keys start sticking or the surface starts looking dull and worn. Most retailers only think about keypad protection after that wear is already visible.
This cover is molded to fit the ISC250 and ISC480 keypad surface completely to the edge, sitting flush enough to work under the privacy shield without interference. It's translucent so the key labels stay visible, flexible enough that presses register the same as they would on a bare keypad, and washable, so it can be reused instead of replaced every time it picks up grime.
Keypad Cover for Ingenico ISC250 & ISC480. Covers Keypad Surface completely to the edge and fits under the privacy shield.
-
Can wash and sanitize the front of the unit.
-
Translucent, Flexible, Durable Overlay
-
Molded to fit over keys
-
Installs in seconds
-
Protects from spills, dust, oil, moisture, and liquid cleaning agents.
-
Antiglare
-
Cleanable and Reusable
-
Polymer: Thermoplastic Polyurethane, Aromatic Polyether (100% Latex Free)
-
Key Attributes: Long-lasting, tough, strong, abrasion-resistant, chemical-resistant
The listed product does not contain any substances classified by Regulation (EC) No. 1907/2006 of the European Parliament concerning the Registration, Evaluation, Authorization and Restriction of Chemicals (REACH) as Substances of Very High Concern (SVHC, updated January 16, 2020).
This compound is a non-PVC product and contains no plasticizers. The resin used to produce ET-90090 complies with FDA CFR 177.2600 and 177.1680 for wet and dry food contact applications and is listed under NSF Article 61. These properties are based on the compound datasheet supplied by the resin manufacturer.
*Terminal Not included
Frequently Asked Questions
Is one cover made for both the ISC250 and ISC480, or do they need different sizes?
The same cover is molded to fit both the ISC250 and ISC480, since the two units share a matching keypad layout, so you don't need to order a separate version for each terminal.
How do I know this will sit flush instead of shifting around during use?
It's molded to the keypad's exact shape and covers the surface edge to edge, so it seats into place rather than resting loosely on top like a flat sheet would.
Will it still work if the terminal already has a privacy shield attached?
Yes. The cover is built to go underneath the privacy shield, so terminals that already have one installed can keep it without needing to remove anything.
How often should this be replaced in a high-traffic checkout?
There's no fixed schedule. Since it's cleanable and reusable rather than disposable, most locations keep it on until it shows visible wear rather than swapping it on a set timeline.
Can it handle the cleaning products used in restaurants or retail counters?
Yes. It's chemical-resistant and rated to hold up against liquid cleaning agents, which is part of why it's suited to counters that get wiped down repeatedly through the day.
Does the antiglare finish affect how the screen or keys look under store lighting?
No. The antiglare surface cuts down on reflection under bright checkout lighting without affecting how visible the keys or labels are underneath.
Why does the listing mention food contact compliance for a card terminal cover?
It reflects the resin's certification (FDA CFR 177.2600, 177.1680, NSF Article 61), which is relevant in settings like grocery counters or food service where the terminal sits near a food-handling area.
Does this order include the ISC250 or ISC480 terminal itself?
No. This is the keypad cover only; the terminal is not included and is sold separately.
